Bush Stick to Handheld Bagless Corded Vacuum Cleaner

Note: The filter cartridge should be cleaned each time dust container is emptied.

Note: The air inlet filter should be cleaned every 3 months.

1. Switch off the vacuum and disconnect it from the mains.

2. Press the dust container Release button and separate the dust container and remove the filter cartridge.

3. Tap the filter cartridge against the bin to remove the dust.

4. Slide the air inlet filter out from the holder.

5. Wash the inlet filter sand the filter cartridge in cool soapy water and rise under running water until the water runs clear.

Note: Never wash the filters in a washing machine.

6. Allow the filters to air dry fully.

Note: Using a damp or wet filter will reduce the suction and damage the motor.

7. Slide the air inlet filter back into the holder and refit the cartridge back into the dust container.

1. Switch off the vacuum using the ON/OFF button and disconnect the mains supply.

2. Remove any of the Nozzles.

3. Press the dust container Release button and separate the dust container.

1. Switch off the vacuum.

2. Unwind the power cable.

3. Press the handle release button and pull upwards.

Note: The floor head and crevice nozzle can just be pulled off.

1. Unwind the cable from the holder and press the release handle button.

2. Pull the handle out of the vacuum. 

3. Remove the floor head.

4. Insert the crevice nozzle directly into the dust container nozzle.

1. Fit the crevice nozzle into the nozzle holder and slide the holder onto the handle tube. 
2. Insert the tube on the handle into the hole on the top of the vacuum and push down until it clicks into place.
3. Insert the floor head into the vacuum cleaner nozzle.
4. Wind the cable into the holder on the back of the vacuum and the stick.

If your vacuum is experiencing a loss of suction, please try the following:

• Check for any debris or blockages in the tubing and main body.
• Ensure the filter has been cleaned and left to dry as per the maintenance and care instructions.
• Check to see if the issue is happening on all attachments. If it is happening with a particular attachment then check there is no damage to this attachment and it is fitted correctly.

If you are still experiencing issues, please get in touch with the support team using the contact details on this page.

If the vacuum is not turning on, please try the following:

• Try an alternative plug socket.
• Change the fuse in the plug.

If there is light and sound but the unit isn’t turning on fully, please ensure the vacuum has been cleaned correctly; check for blockages and clean the filter.

If you are still experiencing issues, please get in touch with the support team using the contact details on this page.

If the vacuum is hard to push, please check try the following:

• Check for any blockages or debris in the floorhead.
• Change the pile adjustment setting for the floorhead if available on the model (please refer to the user manual for the location).
• Check if the issue occurs on different floor types, as thick carpets will be harder to push on.

If you are still experiencing issues, please get in touch with the support team using the contact details on this page.

Check that the dust container is fully clipped into place. Follow any symbols on the dust container and twist/clip on securely.

It is normal for the vacuum to make noise during operation. If the vacuum is making unusual or excessive noises, check the following:

• Check the filter is secure in the dust container as it may be rattling.
• Clean the filter thoroughly to remove any dirt and debris.
• Securely fasten the dust container to prevent parts from moving.
• Check the floor head for any dirt or damage which may be causing the sound.

If the brush roll isn't spinning, check the following:

1. Turn off and unplug the vacuum.
2. Remove any hair or debris that is tangled around the brush roll.
3. Check that the belt on the brush roll is securely attached.

Please note, this only applies to models that have a spinning brush roll.