VAX BLADE PRO 32V CORDLESS STICK

please be advised that this product turns on in 'boost' mode which has an estimated run time of 20 minutes.  In normal mode (switch to this by pressing the boost button - the light will turn white), you will increase the run time to 45 minutes on a full charge.

Remove the wand from the handheld

Drop a ball of paper down the wand to check for blockages

If the paper gets stuck, use a long thin item, such as a broom handle to push any obstructions through the wand

Check the seals.

Open both ends of the dirt container, remove the separator and clean all seals.

Replace the separator, filter and lid.

The machine may not have switched on when you went to use it, or it may have cut out during use.

If you have used the machine in the last 24 hours, it may have overheated and not cooled down enough to switch back on yet.

If your vacuum is experiencing a loss of suction, please try the following:

• Check for any debris or blockages in the tubing and main body.
• Ensure the filter has been cleaned and left to dry as per the maintenance and care instructions.
• Check to see if the issue is happening on all attachments. If it is happening with a particular attachment then check there is no damage to this attachment and it is fitted correctly.

If you are still experiencing issues, please get in touch with the support team using the contact details on this page.

If the vacuum isn’t charging, please try the following:

• Try an alternative plug socket.
• Ensure there is no debris stuck in the charging port or at the end of the charging cable.
• Gently wipe the end of the charging cable with a clean, dry cloth.

If you are still experiencing issues, please get in touch with the support team using the contact details on this page.

Check that the dust container is fully clipped into place. Follow any symbols on the dust container and twist/clip on securely.

It is normal for the vacuum to make noise during operation. If the vacuum is making unusual or excessive noises, check the following:

• Check the filter is secure in the dust container as it may be rattling.
• Clean the filter thoroughly to remove any dirt and debris.
• Securely fasten the dust container to prevent parts from moving.
• Check the floor head for any dirt or damage which may be causing the sound.

If the brush roll isn't spinning, check the following:

1. Turn off and unplug the vacuum.
2. Remove any hair or debris that is tangled around the brush roll.
3. Check that the belt on the brush roll is securely attached.

Please note, this only applies to models that have a spinning brush roll.