Beats Studio3 ANC Over-Ear Wireless Headphones - Black

1. Hold down the Power button and Volume button for 10 seconds. 
2. When the fuel gauge flashes, release the buttons. 

The headphones have now been reset and are ready to be set up with devices again.         

1. Press and hold the Power button for 1 second. 

To charge your headphones, plug them into a power source using the included micro USB cable. As the headphones charge, the five Fuel Gauge lights flash. When your headphones are fully charged, all five lights remain lit. 

Your headphones provide up to 22 hours of playback from 90 minutes of charging and up to 40 hours when you turn off Pure ANC. And with Fast Fuel, your headphones provide up to 3 hours of playback from a 10 minute charge. 

To check the battery level, make sure your headphones are turned on, then tap the power button on your headphones and watch the five Fuel Gauge lights on the right ear cup.

1. On your iPhone, go to Settings and then Bluetooth and make sure Bluetooth is turned on. 
2. Press the power button on your headphones for 1 second.  
3. Hold your headphones within 5cm (2 inches) of your unlocked phone.  
4. Select the headphones from the Bluetooth list on your phone to pair. 
5. Follow the instructions on your phone to complete the pairing. 

Unpair the connection, forget the device and try re connecting. 

Unpair and repair the device, check the connection range of the device and headset. If you are out of range this will cause the connection to drop/disconnect. 

Confirm the headset and device are connected. Check the headset is selected as the default audio device. 

Disconnect and re-connect the headset

Check there is no interference or other connections. Disconnect any other Bluetooth connections from the device.