Hoover Jovis SJ72DA4 Handheld Bagless Vacuum Cleaner

Remove cleaner from storage base, press the on/off switch once to turn on and again to turn off. Empty and clean the unit and filter after each use or when the debris or liquid reaches the maximum fill line.

Fit the Squeegee tool in to assist in collecting liquids. When collecting liquids do not fill beyond the maximum fill line. 

IMPORTANT: Always keep the cleaner vertical (with the nozzle-end down) during and after collection of liquids, to prevent spillage or liquid entering the motor. Always empty the liquid out of the container immediately after use. Do not pick up solvent based solutions, inflammable or combustible liquids. After picking up liquids the container, deflector and filter MUST be thoroughly dried and the squeegee removed before picking up dry dirt.

IMPORTANT: for best results clean the filter after each use. While holding the cleaner in vertical position, press both dust cup release buttons either side of the handle. The dust cup will be released from the main body of the product. Hold the dust cup over a waste bin and use the filter handle to remove the filter/deflector from the dust cup. Empty the dust container and brush the dust and dirt off the filters. The container, deflector (Wet & Dry only) and filters may be washed in warm soapy water. Make sure all are completely dry before replacing in your cleaner. Replace the filter into the dust container and reassemble the dust container to the cleaner.

Place the cleaner into the base, ensuring the shroud covers the back of the product. Note: Use only the charger supplied with your cleaner to recharge the unit. IMPORTANT: Before first use, charge your cleaner for at least 24 hours. When charging the cleaner, the power switch must be off. It is normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use, let the cleaner run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in temperatures above 37°C or below 0°C.

Place the cleaner into the base, ensuring the shroud covers the back of the product. Note: Use only the charger supplied with your cleaner to recharge the unit. IMPORTANT: Before first use, charge your cleaner for at least 24 hours. When charging the cleaner, the power switch must be off. It is normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use, let the cleaner run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in temperatures above 37‚‚°C or below 0‚‚°C

Remove cleaner from storage base, press the on/off switch once to turn on and again to turn off. Empty and clean the unit and filter after each use or when the debris or liquid reaches the maximum fill line.