Ooni Koda 12 Gas-Powered Pizza Oven

1. Check to see if propane tank is empty 

2. Turn the coupling nut about one-half to three quarters additional turn until solid stop. Tighten by hand only - do not use tools 

3. Clear burner tube 

4. Reengage burner and valve

1. Check for gas in propane tank 

2. Turn off gas control knob, wait 30 seconds and light oven. If flames are still low, turn off gas control knob and propane tank valve. Disconnect regulator. Reconnect regulator and leak test. Turn on propane tank valve, wait 30 seconds and then light oven.

1. Turn front of oven away from wind 

2. Refill propane tank 

3. Refer to Sudden drop in gas flow above

Before each use, check all the gas connections for leak testing using the procedure listed below. If the smell of gas is detected at any time, you should immediately stop using and check the entire system for leaks. 

BEFORE TESTING Make sure all packing material has been removed from the appliance. Make a solution of one part liquid detergent and one part water. You will need a spray bottle, brush or rag to apply the solution to the fittings.

TO TEST 

1. Turn the burner valve OFF 

2. Turn the liquid propane cylinder valve on counter clockwise to open the valve. 

3. Apply the soap solution to all gas fittings. Soap bubbles would appear where a leak is present. 

4. If a leak is present, immediately turn the gas supply OFF and tighten leaky fittings. 

5. Turn the gas back ON and recheck. 

6. Should the gas continue to leak from any of the fittings, turn the gas supply OFF and contact the support number on this page.