Spear & Jackson Cordless 3-In-1 Leaf Blower and Vac - 36V

Press the battery capacity level button to check the charging level. The Status/Remaining charge will be shown on the battery charging level indicator light.  

• 3 green LEDs continuously lit = Fully Charged 
• 2 Green LEDs continuously lit = 65% Charged 
• 1 Green LEDs continuously lit = 35% Charged  
• No LED lit = Better is dead and needs to be charged.  

Red LED turn on = Charger ready 

Green LED flash = Battery pack charging 

Green LED continuously lit = Battery fully charged 

Red and Green LEDs Flashing = Battery defect 

Red and Green LEDs continuously lit = Battery pack too cold or warm 

Hold the tool and the battery pack firmly when installing or removing the battery pack. Failure to hold the tool and the battery pack firmly may cause them to slip off your hands and result in damage to the tool and battery pack, potentially causing a personal injury. 

Always switch off the tool before installing or removing the battery pack. 

To remove battery pack, press the release button, and pull out to charge. 

To install the battery pack, align the tongue on the battery pack with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click.  

To start the cordless blower vac, slide the ON/OFF switch forward to show the ON mark. 

To stop the unit, slide the ON/OFF switch backward until the OFF mark appears. 

This unit is equipped with six variable speed settings (1 to 6)  

• Turn the speed dial to position “1” or “2” for LOW speeds. 

• Turn the speed dial to position “3” or “4” for MEDIUM speeds. 

• Turn the speed dial to position “5” or “6” for HIGH speeds. 

Hold the blower firmly with one hand on the main handle and the other hand on the auxiliary handle. Sweep from side to side with the nozzle several inches above the ground or floor. 

Slowly advance the unit, keeping the accumulated pile of debris in front of you. Most dry blowing operations are better suited to low speeds rather than high speeds. High speed blowing is best for moving heavier items like large debris or gravel. 

Once you have blown the debris/leaves into a pile, you can convert to vacuum mode to collect the debris. 

With a firm hold on the vac, tilt the mulcher tubes 2 in – 4 in. (5 cm – 10 cm) from the ground and use a sweeping action to collect light debris. The debris will flow into the bag. Items such as small leaves and twigs will be mulched as they pass through the fan housing. For longer bag life and increased performance, empty the bag frequently 

As the bag fills, suction power will decrease. When this happens, turn the power switch to the OFF position and remove the batteries. Unzip the bag and empty the debris. 

To remove the bag, press the tube release button. Turn the bag upside down and shake out any debris and leaves. 

Remove the batteries from the machine before storing.  

Store the batteries, charger with the cordless blower + vacuum indoors in a clean, dry and locked location out of the reach of children and animals 

Check the battery is fully charged and connected correctly

Turn off and disconnect the battery. Inspect the tube for any blockages or build up.  

Turn off and disconnect the battery. Ensure the air intake is not obstructed. Battery may be too cold, always start at a low speed to allow the battery to warm up.