Winterwarm WWDF20E 2kW Bathroom Heater support (415/2411)

Buy it on Argos.co.uk

Call:

01925 765799

Mon-Fri: Sat-Sun:

9am to 5pm Closed

Email me this page

Enter your email address to have this page emailed to you *

Useful links

Online support

FAQs

Check that the heater is switched on and that the electrical supply to the unit has not been interrupted.
Ensure the room temperature is below the thermostat setting, as the heater will not operate if the desired temperature has already been reached.
If the heater still does not produce heat, allow it to cool and check whether the safety cut-out has been activated.

The heater is fitted with a safety cut-out device to prevent overheating. If airflow is restricted or the unit becomes too hot, the safety cut-out may operate and switch the heater off.
Ensure the air inlet and outlet grilles are free from dust, obstructions, and towels or other items that may block airflow.

Check that the thermostat is set to a higher temperature. The heater is designed primarily for smaller, well-insulated bathrooms and occasional use. If doors, windows, or extractor fans are allowing heat to escape, the room may take longer to warm up.

Inspect the air outlet and air intake areas for dust build-up or obstructions. Reduced airflow can affect heating performance and may cause the overheat protection system to activate.
Turn the heater off, allow it to cool, and clean the grilles in accordance with the instruction manual before using it again.

If you need advice or support for your product, please in the first instance contact the support provider using the number on this support page.

If you still need to return your product then please visit our most up to date returns policy here.