Citizen Men's Stainless Steel Eco-Drive Bracelet Watch

Yes, you can adjust the size of the bracelet. 

Note: The bracelet of this watch uses a premium quality pin and collar system to hold the links securely in place. It should only be adjusted by a professional Jeweller. Be careful to keep the pin and the small collar together with any links that are removed.

If the pins on the bracelet are falling out, check that there is a collar in the link. If the pin has been put back without a collar, the pin will not stay in the bracelet with normal wear. Take the watch back to the Jeweller who adjusted it for them to repair.

Remember Citizen Eco-Drive watches are light powered and most likely just need a charge. Firstly expose your watch to light, your Eco-Drive needs light to operate correctly. While any kind of light will charge your watch, it can take extended periods of time with normal or indoor” lighting. In this instance, if your Eco-drive has completely stopped we recommend charging by exposing your watch to direct sunlight.

This is a Chronograph watch with three dials. The seconds are shown on the 6 oclock sub dial. The large second hand is used like a stopwatch, and can be started and stopped by pressing the top right hand button. You can leave the large second hand running like a nonchronograph second hand. Pressing the lower button will reset the large second hand.

This watch has four removable links either side of the clasp, which can be taken out by a Jeweller to adjust the size of the bracelet. Be sure to keep the links and pins that are removed, in case you need to adjust the bracelet again.

The second hand of the watch can be stopped if the crown is pulled out two clicks. If you pull the crown out when the second hand is at 12 oclock, adjust the minutes, then push the crown in two clicks when the time is changes a minute, the watch will be accurately set

Yes. Eco-drive watches can be charged using any kind of light, however direct sunlight will provide the fastest charging times.

If the pins on the bracelet are falling out, check that there is a collar in the link. If the pin has been put back without a collar, the pin will not stay in the bracelet with normal wear. Take the watch back to the Jeweller who adjusted it for them to repair.