HOVER 1 - H1 IRIDESCENT

As a safety precaution the batteries in Hover-1 may enter a sleep mode. To exit sleep mode, please follow these steps:

1. Plug the charger into the unit.

2. Pick up motorized wheel while plugged in and turn the wheel manually until the charger light starts to flash red.

3. Continue until charging light turns solid red.

4. Follow the charging instructions in the manual. 

Power On: Take your device out of the box and place it flat on the floor. Press the power button (located on the rear of your device) once. Check the LED indicator (located in the center of your device). The battery indicator light should be lit, indicating the device is powered on.

Power Off: Press the power button once.

The H1 may vibrate or spin in one direction, if weight and pressure are applied to only one foot mat.

The display board is located in the middle of the H1 scooter. 

• Green LED light indicates the device is charged above 20 percent. 

• Yellow LED light indicates the power is under 20 percent. 

• Red LED light indicates the power is down to 10 percent or lower

If your H1 is unbalanced, vibrating, or not turning properly, you can follow the below steps to calibrate it.

• First, place the H1on a flat, horizontal surface such as the floor or a table.  The foot mats should be even with each other and not tilted forward or backward.  Make sure the charger is not plugged in and the board is turned off.

• Press and hold the ON/OFF button for a total of 15 seconds. The scooter will turn on, lighting the battery indicator on the board.

• Turn the board off and then turn the board back on. Press the power button twice. Calibration will now be completed.