Black + Decker 18V Cordless Hammer Drill with Battery

If the drill will not start, check the following: 

• Ensure the battery is fully charged.
• Check that the battery is fully inserted until it clicks into place.
• Ensure the selector switch is not set to neutral.

Please check the instruction manual for the above procedures.

If the drill bit slips during drilling, check the following: 

• Check that the drill bit has been inserted correctly.
• Remove the drill bit and check for any debris on the jaws.
• Ensure the chuck has been sufficiently tightened.

Please check the instruction manual for the above procedures.

If the performance of the drill is poor, check the following: 

• Ensure the correct gear has been selected.
• Ensure the clutch ring is set to drill.
• Check that the correct drill bit is being used for the surface you are drilling.

Please check the instruction manual for the above procedures.

• Ensure the battery is fully charged and correctly inserted into the drill (Check the instruction manual for this procedure).

• Check the drill bit for wear and damage as this can cause slipping. 
• Ensure the drill bit is securely inserted into the chuck and properly tightened. 

If your drill stops during use, check the following: 

• Check the battery level, before using the drill ensure the battery is fully charged. 
• Check that the battery has been properly fitted (check the instruction manual for this procedure). 
• If your drill has overheated, it will stop. Ensure you use the correct drill bit for the material you are drilling to prevent overheating (check the instruction manual for guidance on what drill bit to use). 
• Allow the drill to fully cool before using it again. 
• Regularly switch off the drill, then clear any obstructions from the drill bit and chuck.