Ninja SLUSHi Frozen Drink Maker

If the vessel is not installed correctly, the unit will detect it and provide an alert. All pre-set LEDs will flash.

• With the bail handle up, slide the vessel over the installed auger and evaporator.

• Lock the vessel in place by pushing the bail handle back to seal the vessel.

• Press the Power button to turn unit on, and the pre-set LEDs will illuminate, indicating the unit is ready for use.

If the alcohol and sugar content of the input is too high, the unit will detect it and provide an alert. Temperature Control LEDs will flash one at a time in ascending order starting with the bottom LED, preset LEDS will flash, and the unit will beep every minute for 15 minutes

If your recipe has not reached desired texture after 60 minutes, increase the temperature by one level. Wait 10–15 minutes to test recipe texture. If still not desired, increase by one level again. Repeat until desired texture is achieved.

For the best dispensing experience, fill the unit to the max fill line and ensure the unit is running. For a smoother dispense experience, decrease the temperature level by pressing the bottom arrow on the control panel. More sippable frozen drinks will dispense smoother.

For best results, use the Rinse Cycle before disassembling and cleaning all parts to rinse frozen drink off the evaporator by following the steps below. 

• Dispense any remaining frozen drink.
• Stop the current preset. Press the RINSE button.
• Add warm water up to the vessel’s max fill line.
• Slowly dispense the water from the unit immediately after filling. Ensure you use a large cup or bowl to capture the liquid.
• Stop Rinse cycle by pressing the RINSE button again.
• Press the power button to turn the unit off.
• If needed, repeat until frozen drink is rinsed off the evaporator. 
• After using the Rinse cycle, wash all parts by hand or in a dishwasher to fully clean the unit after each use.

If the motor stalls while running, the unit will detect it and provide an alert. Every Temperature Control LED will flash, and the unit will beep twice every minute for 15 minutes. Follow all steps below to correct the error.

• This unit features a unique safety system that prevents damage to the motor and drive system should you inadvertently overload it. If the unit is overloaded, the motor will be temporarily disabled.
• Unplug the unit from the electrical outlet.
• Allow the unit to cool for approximately 15 minutes.
• Remove all parts and accessories. Ensure no ingredients are jamming the auger.
• Plug in the unit again and reassemble all parts to resume unit use.

If the unit is on its side during use, the unit will detect it and provide an alert. The top 5 and bottom 5 Temperature Control LEDs will flash alternately, and the unit will beep twice every minute for 15 minutes. Follow the step below to correct the error.

• Place the unit upright and let it stand for at least 2 hours before using.