One For All URC1915 Grundig TV Replacement Remote Control

If you would like to delete a learned function that you no longer require, please follow the procedure outlined below:

1. Press and hold the Green and Yellow keys until the light blinks once and then twice.
2. Enter 976, the LED will blink twice.
3. Press the learned key you wish to reset twice, the LED will blink twice.

Additional Information:

You can delete a learned key by overwriting it with a new learned function. 

If a learned function used in a macro is subsequently deleted, the macro will revert to sending the keys original function.

Your One For All remote is capable of copying functions straight from the original remote control that came with your device.

To use the Learning feature, please follow the instructions below:

1. Press and hold the Green and Yellow keys until the light blinks once and then twice.
2. Enter 975, the LED light will blink twice.
3. Press the key on the Replacement remote where you would like to place the learned function, the LED will flash rapidly.
4. Press and hold the key on the original remote control that you wish to learn until the LED on the replacement remote blinks twice.
5. Repeat the above two steps by pressing any other key you wish to learn on.
6. Press and hold the OK key to store the learned function until the LED blinks twice.

A long blink indicates that the remote failed to learn the signal from the original remote.

There could be a number of reasons for this.

1. Make sure the original remote that came with the device is in working order, by testing it on your device. If it is not responding, it might not be working correctly.
2. Make sure you are not performing the learning procedure under bright lighting or in bright sunlight as this can interfere.
3. Ensure that the two remotes are approximately 2 to 3 cm apart, and that the transmitting end of the original remote is facing the remote. Sometimes holding the key on the original remote down for slightly longer may help, and conversely sometimes quickly pressing and releasing the key on the original works better.
4. The batteries used should have sufficient power. Even though the remote works when using it to switch on and off devices, it might not have enough power to be able to learn additional functions. Please replace a new set of batteries
5. It is also possible that the memory on your remote control has reached the maximum capacity due to too many learned or other customised functions. Please remove some existing learned keys.
6. Some manufacturer’s remotes use a different signal, or infra-red protocol, that the One For All remote cannot reproduce. These are commonly signals that use a higher frequency. Radio frequency remotes cannot be learned from, because these signals are not infra-red based.