REMINGTON FOIL 7808 WITH NOSE TRIM WOW

Care for your appliance to ensure a long lasting performance. We recommend you clean your product after each use. The easiest and most hygienic way to clean the appliance is by rinsing the appliance head after use with warm water. Keep the switch in the off position when not in use.

Ensure your skin is dry. Always hold the shaver at right angles to the skin so that all three heads are touching the skin with equal pressure. Use moderate to slow stroking movements. The use of short linear motions in stubborn areas may obtain a closer shave, especially along the neck and chin line. DO NOT press hard against the skin in order to avoid damage to the foil.

The battery must be removed from the appliance before it is scrapped. The appliance must be disconnected from the supply mains when removing the battery. Using a small screwdriver, pry off the 2 side panels. Using a Philips screwdriver remove the 4 screws from the front of the shaver and remove the front housing. Using a Philips screwdriver, remove the 8 screws from the front of the shaver. Remove and open the core from the shaver to expose the batteries. Cut the wires connecting the batteries to the circuit board and remove the batteries. The battery is to be disposed of safely.

If your shaver battery is completely empty or the shaver has not been used for an extended period of time, the shaver may not start when operated using the cord. If this occurs, a 5 minute quick charge will allow for 3 minutes of shaving.

Irritation: as foils get worn, you may experience skin irritation. Pulling: as the cutters wear, your shave may not feel as close and you may feel the cutter pulling your hair. Wear through: you may notice that the cutters have worn through the foils.

Grasp the cutter between your thumb and forefinger and pull upwards. Snap the new cutter into the oscillator tip. Note: DO NOT press on the cutter ends as this may cause damage.