Braun Series 7 790cc-4 Electric Shaver

After each shave, return the shaver to the Clean&Renew station. All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricants, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper.

The hand-held unit shall be detached from the power supply cord before cleaning. The shaver shall not be used until it has dried. Rinsing the shaving head under running water is an alternative way to keep the shaver clean, especially when travelling: Switch the shaver on (cordless) and rinse the shaving head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. Next, switch off the shaver, press the release button to remove the foil and cutter cassette and let it dry. If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the foil and cutter cassette. Alternatively, you may clean the shaver using the brush provided: Switch off the shaver. Remove the foil and cutter cassette and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. However, do not clean the cassette with the brush as this may damage it.

For best shaving results, Braun recommends you follow 3 simple steps: 

1. Always shave before washing your face. 
2. At all times, hold the shaver at right angles (90°) to your skin. 
3. Stretch your skin and shave against the direction of your beard growth.

From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests.

After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section Before shaving. All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be suffi cient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricates, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper.

A full charge provides up to 50 minutes of cordless shaving time. This may vary according to your beard growth. The best environmental temperature for charging is between 41 °F to 95 °F / 5 °C to 35 °C. Do not expose the shaver to temperatures higher than 122 °F / 50 °C for extended periods of time.

From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests.

After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.