Oregon Projection Temperature Alarm Clock

Press RCC to turn. When you have rest the product the reception takes 2 to 10 minutes. If the signal is weak it can take up to 24hours to get a valid signal.

Make sure the product is set to UK time, press RCC to turn on and select the desired region

Press RCC to turn. When you have rest the product the reception takes 2 to 10 minutes. If the signal is weak it can take up to 24hours to get a valid signal.

The clock will only project constantly when connected to the mains via the adaptor supplied. If not connected to the mains the clock will project only for 5 to 10 seconds. Press and hold the Projection button in the battery compartment to toggle between continuous projection on/off.

Check the channel on the sensor (to be found in the battery compartment) corresponds to the channel on the main unit. For the main unit press + on the top of the clock to toggle through. Bring the sensor next to the main unit and press the reset button on the main unit and then the sensor. Leave for around 20 minutes and then should pick up the sensor which can then be placed back outside. If this does not resolve the issue then batteries should be replaced in the main unit and the sensor and reset procedure again.