PDP REMATCH GLOW Advanced Xbox Wired Controller Mister Peeks

The glow function only works after sufficient exposure to a light source—especially ultraviolet (UV) light. Make sure you “charge” the design under a bright light for a few minutes. Some users report that standard indoor lighting may not activate the glow well.

There are two trigger‑stop switches located under the controller, one for each trigger. Slide each switch down to engage the 2‑way true hair triggers, reducing travel distance for quicker input response

Use the free PDP Control Hub app (for Xbox or PC) to re‑map the back paddle buttons, adjust dead zones, and check trigger configuration. After mapping, ensure firmware is up to date. If things still aren’t registering, try resetting mappings or reinstalling the app.

First, swap to a different USB‑A or USB‑C port and test with another device. If still unrecognised:

• Launch the PDP Control Hub app.

• Check for firmware updates and apply them.

• Restart your system to allow it to re-hook the driver.
  If none of these work, the cable may be faulty—consider replacing with a third‑party USB‑C cable that supports data transfer.

• Check the USB cable: Try a different USB cable if possible to rule out a faulty cable.

• Try a different USB port: Connect the controller to another USB port on the Switch dock.

• Restart the Switch: Power cycle the console by holding the power button and selecting restart.

• Update Switch firmware: Make sure your Switch system is up to date.

• Test on another device: Try plugging the controller into a PC to see if it gets recognised.

• Reset the controller: Some PDP controllers have a small reset button; press it with a pin.

• Reconnect the controller: Unplug and replug the controller.

• Check for debris: Make sure nothing is stuck under buttons.

• Test with another controller: To verify if the issue is with the controller or the console.