Kenwood KMX750AC kMix Stand Mixer - Cream

This would indicate the tool is at the wrong height and needs adjusting. To rectify, adjust the height using a suitable spanner.

This would indicate the Speed control not in the ‘O’ position. To rectify, check and turn speed control to the ‘O’ position.

This would indicate the Overload protection or overheat system activated or the maximum capacity exceeded. To rectify, try the following:

1. Unplug and check for obstruction or overloading. 
2. Turn the speed control to “O” and then restart. 
3. If the machine will not operate, remove some of the ingredients to reduce the load and restart.
4. If this still does not resolve the problem, unplug and allow to stand for 15 minutes. Plug in and reselect the speed. 

This means the Stand mixer has been left plugged in for more than 30 minutes without being operated and has gone into Standby mode. To rectify, turn the speed control to ‘min’ then return to ‘O’ to reset the machine.

• Check the power plug is fully inserted.
• Test the socket with another appliance.
• Ensure any safety locks or attachments are fitted correctly.

• Place the mixer on a flat, stable surface.
• Reduce the amount of mixture in the bowl.
• Check that the rubber feet are clean and undamaged.
• Use the recommended speed setting for heavy doughs.

• Turn the mixer off and unplug it.
• Remove and refit the attachment securely.
• Reduce the quantity of ingredients.

• Check the bowl is correctly fitted and locked.
• Remove and refit the attachment.
• Ensure you are using the correct attachment for the task.
• Start on a low speed and gradually increase.

• Turn the mixer off and unplug it.
• Allow it to cool down before using it again.
• Avoid exceeding the recommended mixing times.
• Reduce heavy loads and large batch sizes.